Table of Contents
Advertisement
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
Requirements
¡ The appliance is switched off.
¡ Ensure that the heat-sealing bar in the vacuum-seal-
ing compartment has cooled down.
Clean the appliance with a damp cloth and neutral
1.
cleaning agents, such as washing-up liquid and wa-
ter.
During cleaning, ensure that no water or other liquid
gets into the vacuum-sealing compartment or, in
particular, into the vacuum pump's air outlet.
Never spray the inside or outside of the appliance
with water.
Leave the appliance and accessory parts to fully dry
2.
after they have been cleaned.
10.3 Cleaning the glass front and glass lid
Clean the glass front and the glass lid with glass
▶
cleaner and a soft cloth.
Do not use any abrasive sponges that may scratch
or any glass scrapers.
10.4 Cleaning the stainless steel vacuum-
sealing compartment
Always remove limescale, grease, starch or albumin
1.
stains immediately. Corrosion can form under such
stains.
11 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
11.1 Malfunctions
Fault
The vacuum-sealing
process will not start.
does not appear
even though the lid is
closed.
Cause and troubleshooting
The door switch on the glass lid is missing or is not detected by the appliance.
Call the after-sales service.
▶
→ "Customer Service", Page 13
Clean with water and some washing-up liquid.
2.
Dry with a soft cloth.
3.
10.5 Cleaning the plastic control panel
Clean the control panel using a soft cloth.
▶
Do not use any abrasive sponges that may scratch
or any glass scrapers.
10.6 Cleaning the heat-sealing bar
ATTENTION!
Cleaning in the dishwasher leads to damage.
Never clean the appliance components in the dish-
▶
washer.
Remove the remaining film from the heat-sealing
1.
bar.
Never use abrasive cleaning agents to clean the
2.
heat-sealing bar.
Dry with a soft cloth.
3.
10.7 Cleaning the accessories
ATTENTION!
Cleaning in the dishwasher leads to damage.
Never clean the appliance components in the dish-
▶
washer.
1.
Clean using a sponge cloth and hot soapy water in
the direction of the finish.
Dry with a soft cloth.
2.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
Troubleshooting en
9
Advertisement
Table of Contents
