Control Panel; Operating Modes - Danby DPA140HBACBDB Owner's Manual

OPERATING INSTRUCTIONS

CONTROL PANEL

3sec
1 2 3
1. Swing Button: Press to start the auto swing
feature. When auto swing is activated, press
again to stop the louver at the desired angle.
2. Fan/Ionizer Button:
• Press to select fan speed; normal or high. Light
will indicate current speed.
• Press and hold for 3 seconds to activate the
ionizer function.
3. Timer Button: Press to start the Auto-on or Auto-
off features. Light will indicate whether a timer is
set.
4. Up and Down Buttons:
• Used to set the temperature and timer.
• Press and hold both Up and Down buttons for 3
seconds to change the temperature display from
°C to °F.
5. LED Display:
• Shows the set temperature in °C or °F or the
auto-timer settings.
• While on Dry mode shows the relative humidity.
• When on Fan mode shows the room
temperature.
6. Sleep/Filter Button:
• Press to start the Sleep function.
• The fi lter light will illuminate after 250 hours of
use as a reminder to clean the fi lter; to reset the
fi lter after cleaning, hold the Sleep button for 3
seconds.
7. Mode Button: Press to select the desired mode.
Modes will cycle in sequence with each press of
the button; Auto, Cool, Dry, Fan, Heat. Light will
indicate current mode.
8. Power Button: Press to turn the unit on or off.
5
3sec
4 6 7

Operating Modes

• Cool Mode
Choose Cool Mode to set the cooling function. Use
the Up and Down Arrows to choose the desired
temperature. When Cool Mode is selected, the fan
8
speed can be adjusted by pressing the fan button.
The temperature can be set within a range of 17 -
30°C (62 - 86°F).
The exhaust hose should be installed during Cool
Mode to ensure the best results.
• Dry Mode
Choose Dry Mode to remove excess moisture
from the air during periods of high humidity. All
water pulled from the air will condense inside the
appliance and drain out the back.
The humidity can be adjusted in 5% increments
between 35% and 85%.
The fan speed will be automatically set and cannot
be modifi ed in Dry Mode.
• Fan Mode
Choose Fan Mode to run the internal fan without
engaging the cooling function. Press the fan button
repeatedly to choose the fan speed, Low, Med, High
or Auto.
• Auto Mode
Auto Mode is a pre-set factory program that
automatically defi nes the mode (Cool or Dry)
and fan speed based on the set temperature, the
ambient temperature and the ambient humidity.
• Heat Mode
Choose heat mode to set the heating function. Use
the up and down arrows to choose the desired
temperature. Press the fan button to adjust the fan
speed.
The temperature can be set within a range of 13 -
27°C (55 - 81°F).
7