Hunter 50580 Installation Manual page 9

Remove the cardboard plug
guard before proceeding!
Connect the plugs from the fan and light fixture.
Make sure to line up the colored markings on
the connectors.
Repeat x3
Ceiling Bracket Downrod
Push the connector and
excess wire into the hole at
the top of the light fixture.
IMPORTANT
The connector and excess wiring
must be pushed into the light
fixture in order to successfully
mount the light fixture to the fan.
HOLD HERE
Installing the Bulbs and Glass
Metal
Plate
Globe
Install a bulb into each
of the sockets. When
Globe
necessary, replace with
Keeper
bulbs of same wattage.
Finial Cap
Hanging Fan Wiring
Assembling the Light
Raise the light kit to the bottom of the fan.
Align the notch on the mounting ring on the
top of the light kit with the pin in the mounting
bracket on the bottom of the fan.
Hold the fan body stationary and rotate
the light fixture clockwise to engage the
locking pin.
Press the globe flush against the metal plate.
With other hand, press the globe keeper over
the threaded rod until it cups the glass and
immediately install the finial cap and screw
the finial onto the threaded rod.
Finial
Canopy Blades
Notch
Some components not shown for visual clarity.
WARNING
FAN FALL HAZARD
Make sure to secure the light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Remote
1886
Pin
8
Troubleshooting