Screw specifications
M2 x L3
Go to
https://support.lenovo.com/partslookup
part:
Wi-Fi card
Remove the hard disk drive (HDD) module
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2.
Disconnect the HDD cable from the system board and remove four screws. Remove the HDD
module.
Figure 9. Remove the HDD module
Screw specifications
M2 x L3
Step 3.
Remove the HDD cable.
Figure 10. Remove the HDD cable
Step 4.
Remove four screws and then separate the HDD bracket and the HDD.
34
Hardware Maintenance Manual
Number of screws
1
to look up the Lenovo part number of the following replacement
Number of screws
4