Table of Contents
Advertisement
Step 1.
Disconnect the EDP cable from the system board then detach the main and auxiliary antenna
connectors. Release EDP cable and antennas from cables from the cable guides.
Figure 20. Detach the EDP cable and antenna connectors
Step 2.
Disconnect the camera cable from the system board.
Figure 21. Disconnect the camera cable from the system board
Step 3.
Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove four screws and then remove the LCD unit.
.
Chapter 4
Removing a FRU or CRU
41
Advertisement
Table of Contents
