Table of Contents
Advertisement
SLC300
Initial Start Up
After the final check list has been gone through,
Ice Size Adjustment
the ice machine may be started up.
1. Open the water shut off valve; the inlet water
valve will open, and water will flow into the
Ice Thickness
reservoir..
Probe Adjustment
2. Switch on the electrical power.
Set
Plate:
Screws
Up for LARGER
3. Remove the front panel.
Down for SMALLER
3. Locate the ICE/OFF/WASH switch, switch
it to WASH.
4. The water pump will begin to pump water over
the evaporators.
5. Allow the reservoir to refill. Normal water level is
Cube Size Diagram
1/8" below the high point of the lower curve of the
siphon u-tube.
6. Switch the ICE/OFF/WASH switch to OFF.
7. Check the action of the siphon. The water level
in the reservoir should drop to the bottom curve of
Cubes Too
the U-bend (normal water level) in about 2
Thick
minutes. If not, check for proper drain tube
connections.
8. Switch the ICE/OFF/WASH switch to ON.
9. On air cooled models the fan motor will begin to
turn, and warm air will be discharged from the
back of the ice machine.
On water cooled models warm water will begin to
flow from the condenser drain.
10. The water temperature in the reservoir will
0
soon be 32
F., and ice should begin to form on the
evaporators.
11. Allow the ice machine to operate for about
Correct Size &
11 16
1
"
15-20 minutes. The ice should be fully formed and
Shape
should be harvested within a few minutes.
12. After harvest, check the ice cube size.
Compare a fresh cube to the diagram on the
back of the front panel. If needed, adjust the
cube size by loosening the two set screws and
moving the ice thickness probe plate.
Move the plate down for smaller cubes and up
for larger. Re-tighten set screws.
For proper operation, the ice thickness should be
11
set to the 1
" diameter.
16
Cubes Too
The machine is designed to harvest cubes of
Thin
only the correct thickness.
January 1993
Page 12
Advertisement
Table of Contents
