Table of Contents
Advertisement
MCM1062R
CLEANING
SANITIZE WATER SYSTEM
1. Remove and discard all ice from the bin.
2. Remove front panel.
3. Drain the reservoir
4. Prepare 2 gallons of an approved sanitizer
solution in accordance with the instructions on the
package.
5. Pour 1 gallon of the sanitizer into the ice maker
reservoir.
6. Move the main switch to "Wash", and allow the
solution to circulate for a MINIMUM of 5 minutes.
7. Move the main switch to "Off".
8. Pull out the drain plug and drain the reservoir.
9. Using a clean sponge and the remainder of the
sanitizer solution, wipe the interior of the
evaporator cover and the inside of the storage bin,
taking care to wipe all surfaces that are normally in
contact with ice.
10. Replace the evaporator cover. Replace the
front panel.
11. Move the master switch to ON.
SCOTSMAN REMOTE CONDENSER
1. Disconnect electrical power at the icemaker.
///////////////////////////////WARNING///////////////////////////
Disconnect electrical power before beginning.
////////////////////////////////////////////////////////////////////////////
2. Wipe off any surface dust from the intake side of
the condenser.
3. Vacuum the coil, or clean with coil cleaner.
4. The coil is clean when light can be seen through
the fins.
5. Reconnect electrical power.
SANITIZE ICE STORAGE BIN
This procedure is to be done monthly
1. Remove and discard all ice from the bin.
2. Switch the ice maker off.
2. Prepare 2 gallons of an approved sanitizer
solution in accordance with the instructions on the
package.
3. Using a clean sponge wipe the inside of the
ON/OFF/WASH
SWITCH
October 1993
Page 20
storage bin and door,
taking care to wipe all
surfaces.
4. Rinse the interior of
the storage bin using
clean water and the
sponge used in step 3.
5. Switch the ice
machine back on.
RESERVOIR
DRAIN
Advertisement
Table of Contents
