Removal And Replacement: Reservoir - Scotsman FME1504R Service Manual

REMOVAL AND REPLACEMENT: Reservoir

WATER RESERVOIR
1. Shut off the water supply to the icemaker.
2. Remove front panel and reservoir cover.
3. Disconnect water inlet compression fitting at
reservoir inlet.
4. To remove float push locking tab in and pull float
valve up and out of the reservoir tank.
Note: there is a plunger inside the valve that is
available separately.
5. To remove reservoir, remove drain hose from
reservoir.
6. Remove evaporator inlet hose from reservoir.
7. Pull water sensor from reservoir.
8. Remove mounting screws from reservoir
bracket, and remove reservoir from icemaker.
9. Reverse to reassemble.
ICE DISCHARGE CHUTE
SLIDE THE
SENSOR
HOLDERS LEFT
TO REMOVE
FROM THE ICE
CHUTE
NME1254R & FME1504R
FLOAT
ASSEMBLY
LOCKING
TABS
BIN CONTROLS (Ice Level Sensors)
1. Disconnect electrical power.
2. Remove front panel.
3. Remove control box cover.
4. Locate ice chute, at the base of the chute, in
front of and behind it are two plastic bin control
mounts.
5. Slide each bin control to the left, and in the
control box, disconnect the electrical leads
connecting the bin control to the circuit board.
6. Reverse to reassemble, be certain that the bin
controls are aligned so that the ice level sensors
are visible (centered) through the holes in the cube
chute.
January 2000
Page 27
Water
Sensor