For The Installer - Scotsman FME1200 Service Manual

NME950 & FME1200

FOR THE INSTALLER

BACK VIEW: AIR COOLED
WATER INLET
3/8" FLARE
DRAIN
3/4" FPT
This machine is designed to fit the following
Scotsman storage bins:
B90 and extensions (with bin top KBT18)
BH800 using bin top KBT15 (one unit).
BH800 (two units, no bin top required).
BH900 with KBT24 (one unit)
BH900 with KBT25 (two units side by side)
When installing a new system, check to be sure
that everything is on site before beginning:
Correct Bin
Correct Ice Machine
Correct Bin Top (if required)
All kits, legs, and information required for
the specific job.
SPECIFICATIONS : ICE MAKER
Model Number Dimensions
FME1200AE-3A 21" x 24" x 27"
FME1200WE-3A
FME1200AE-32A
FME1200WE-32A
NME950AE-3A
NME950WE-3A
NME950AE-32A
NME950WE-32A
Note: Allow 6"
behind and 6"
above either unit
for air circulation,
utility connections,
and service.
ELECTRICAL
INLET
9.5"
5.25"
3"
2.1"
5.7"
Basic
Electrical
(w/o bin)
W x D x H
208-230/60/3
same same
same 208-230/60/1
same same
same 208-230/60/3
same same
same 208-230/60/1
same same
Condenser Inlet 3/8" FPT
Condenser Drain 1/2" FPT
DRAIN
3/4" FPT
Installation Limitations:
This ice system is designed to be installed indoors,
in a controlled environment:
Air Temperature
Water Temperature
Water Pressure
Voltage
(Compared to the nameplate)
Operating the machine outside of the limitations is
misuse and can void the warranty.
The normal finish for the ice machine is
enamel-sandalwood. A stainless steel panel kit,
SPKFM21 may be field installed to convert the unit
to a stainless steel finish.
Ice Type Condenser
Type
FLAKE Air
same Water
same Air
same Water
Nugget Air
same Water
same Air
same Water
January 1995
Page 2
BACK VIEW: WATER COOLED
2.9"
3.4"
4.9"
7.46"
Min Max
0
50 F 100
0
40 F 100
20 PSI 80 PSI
-5% +10%
Refrigerant Charge*
Air Cooled 30 oz
R-404A
Water 24 oz
Cooled R-404A
* Always go by the
nameplate charge.
Note: 50 Hz (-6) models have
also been produced.
ELECTRICAL
INLET
WATER
INLET
9.43"
7.3"
5.25"
3"
0
F
0
F