Storage Bin; Location - Scotsman FM2402 Service Manual

FM2402
FOR THE INSTALLER
Typical Storage Bin with Extension and Bin Top

Location:

After uncrating and inspection, the unit is ready for
installation. It is important that the machine be
installed in a location where it has enough space
around it to be accessible for service, and
minimum of 6" be allowed at the back for air
circulation on air cooled models. Try to avoid hot,
dirty and crowded locations. Be sure that the
location for the machine is within the limitations
described on page 3.

Storage Bin:

Tip the storage bin on its back, using parts of the
carton to protect the exterior finish. Install the legs
into the threaded holes in the bottom of the bin.
Turn the leg levelers all the way in preparation for
leveling later. Return the bin to the upright
position, remove paper covering the bin gasket.
Note: Do not push bin into position, but lift it there.
Pushing a bin, especially one with ice in it, can
cause damage to the legs and the leg mounts.
Install the appropriate bin top on the bin, according
to the instructions for the bin top.
Ice Maker:
The machine is heavy, so the use of a mechanical
lift is recommended for lifting the machine high
enough to install on top of the bin. After the unit is
placed on the bin, line it up so it is even with the
back side. Secure the machine to the bin with the
hardware provided with the machine.
Remove the front panel and remove any shipping
blocks.
August 1993
Page 4