Scotsman DC33 Service Manual page 6

DC33
TO INSTALL: Plumbing
Free Standing Cabinet, Pump Model:
1. Remove the kickplate and control box cover.
2. Route the water supply, which should be a 1/4"
O.D. copper tube through the back of the cabinet
to the front.
3. Install a flare nut and flare the end of the tube.
4. Flush the water line and fasten the flare nut to
the male flare on the inlet water valve.
5. Locate the coil of plastic tubing shipped in the
storage bin.
6. Connect the coiled tubing to the discharge port
of the drain pump.
Air Gap Device
(Where Required)
Drain
Connection
Water Shut
Off Valve
Water Filter
(Recommended)
7. Route the discharge line from the drain pump to
the drain point connection. Do not connect to a
drain/waste line below a trap. Connect the
discharge line to the drain, per local codes. An air
gap will likely be required between the ice machine
drain tube and the drain/waste receptacle.
8. Turn on the water and plug in the ice machine.
Pour in a couple quarts of water, the drain pump
should start. Check for water leaks.
9. Replace the kickplate and control box cover.
10. Level the unit using the leg levelers.
ALL PLUMBING MUST MEET LOCAL CODES
THE DC33 WILL FIT IN A SPACE
1 4
15
THE DEPTH OF THE CABINET IS 22" TO
THE FRONT EDGE OF THE HANDLE.
July 1994
Page 6
3 4
" WIDE X 33 " HIGH.
WATER AND DRAIN
INSTALLATION
Drain Tube
From Back Of
Machine
Water Inlet Connection