Door Kit - Scotsman DC33 Service Manual

DC33
TO INSTALL: Add On Kits
Door Kit: The door may be modified to accept a
decorator door panel.
Customizing Door Panel:
A custom door panel may be installed in front of
the standard one. Any panel 14
1
high and " thick or less at the edges may be
4
used as a decorator panel. Examples of decorator
panels include wood to match the adjacent
cabinets; metal of different colors to match nearby
appliances; or just about any material that will fit.
Scotsman has a stainless steel panel available to
fit this machine, the kit number is SS33.
If the material is less than 1/4" thick, the space
between the new panel and the original may be
filled with cardboard.
1. Remove single screw and the left
hand hinge filler plate from the top of the
door.
2. Remove two screws from the top of
the door and lift off the door handle.
3. Open the door slightly, about
one-third or so; then, remove the front
screw holding the hinge to the door.
4. Loosen the rear screw of the hinge
just enough to allow the door to sag or
move forward. This will allow access to
the top of the channels at the right and
left edges of the door.
5. From the top of the door, insert the
decorator panel (pre-cut) evenly into the
channels; carefully slide the panel all
the way down until the panel is fully into
the bottom channel.
6. Check that the panel is the in all the
way and does not protrude past the top
edge of the door.
7. Push the top hinge corner of the door
IN to align screw hole in the hinge with
the screw hole in the door. Install the
screw previously removed. Tighten the
other screw.
8. Replace the door handle and filler
plate; secure with screws previously
removed.
3 15
" wide, 28 "
4 16
Custom Panel,
Thin Panel
Shown With Filler
Hinge
Filler Plate
July 1994
Page 10
Note: These Two Kits Are Currently
Available to Change Panel Color:
TP33 contains 2 sandalwood panels.
WP33 contains 2 white panels.
Parts Involved in Customizing Door Panel
Hinge
Door
With
Groove
Door Handle