For The Plumber - Scotsman CMS1202 Service Manual

CMS1202

FOR THE PLUMBER

FOLLOW ALL LOCAL CODES:
The recommended water supply line is a 3/8-inch
O.D. copper tubing with a minimum operating
pressure of 20 PSIG and a maximum of 80 PSIG.
Connect to cold water supply line with standard
plumbing fittings, with shut off valve installed in an
accessible place between thewater supply and the
cuber. ln some cases a plumber will be required.
Water Limitations:
An ice machine is a food manufacturing plant, it
takes in a raw material, water, and turns it inot a
food product, ice. The purity of the water is very
important in obtaining pure ice and in maximizing
product life. It is generally better to filter the water,
although there is no one filter that will cure all
water problems. A good filter combined with a
polyphosphate feeder gives about the best overall
performance.
OPTIONAL
FILTER
POTABLE
WATER
SUPPLY
AIR GAP
BETWEEN
DRAIN LINES
AND
BUILDING
DRAIN
AIR COOLED
CONNECTIONS
3/8" MALE
FLARE
3/4" FPT
WATER SUPPLY AND DRAIN CONNECTION
DRAIN
Connections: All drains are gravity type and must
have a minimum of 1/4-inch fall per foot on
horizontal runs. The drains to be installed to
conform with the local plumbing code. Install a
vertical open vent on drain line high point to insure
good draining. The ideal drain receptacle is a
trapped and vented floor drain. Recommended bin
drain is 5/8 inch O.D. copper tubing and should be
vented and run separately. Insulation for high
humidity areas is recommended.
Terminate drains above the drain receptacle with
the proper air gap per local code.
The ice machine sump drain is 3/4" FPT. There
must be a vent at this connection for proper sump
drainage.
WATER COOLED MODELS: On water cooled
models, a separate cold water supply inlet is
required, to be connected to a 3/8-inch female
pipe thread (FPT) fitting at the rear of the cabinet.
An additional drain line is required to drain the
water cooled condenser, and must not
interconnect to any other of the unit's drains.
SUMP DRAIN MUST
BE VENTED
HAND SHUT OFF
VALVE
AIR GAP
BETWEEN DRAIN
LINES AND
BUILDING DRAIN
September 1993
Page 6
WATER COOLED
CONNECTIONS
CONDENSER
INLET
VENT
BIN
DRAIN
CONDENSER
DRAIN