Screw specifications
M2 × L3.5
Go to
https://support.lenovo.com/partslookup
replacement part:
Fan
Remove the fingerprint reader board module
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the heat sink" on page 35
Step 1.
Remove the left fan.
Note: For details, see "Remove the fans" on page 36.
Step 2.
Disconnect the fingerprint reader board cable from the system board. Remove two screws and
then remove the fingerprint reader board with cable.
Figure 16. Disconnect the fingerprint reader board cable and remove the fingerprint reader board with cable
Screw specifications
M1.2 x L2
Step 3.
Separate the fingerprint reader board cable from the fingerprint reader board.
Number of screws
4
to look up the Lenovo part numbers of the following
Number of screws
2
.
Chapter 4
Removing a FRU or CRU
37