Parts Names And Instructions; Overload And Overheating Protection - Panasonic MJ-CB800 Operating Instructions Manual

■
Juicer
Food Pusher
Feeding Tube
Container Cover
Spinner Pad
Spinner
Container Unit
Cup Cover
Pulp Container
(Approx. 2.0 L)
Safety
Lock Pins
● The SAFETY LOCK has been designed to prevent the blender or the wet & dry mill from switching on when the
blender jug or the mill container is not properly in place.
● Do not push the safety lock pins with any instrument, stick etc.
Attach the blender jug or mill container to each container base properly.
● After setting, make sure the bottom of each container base is as shown in the illustration.

Overload and Overheating Protection

In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
● Do not use the appliance repeatedly without any countermeasure.
1
Turn the rotary switch to "0" position, unplug the appliance.
2
Remove attachment from motor housing. Remove the excess ingredients from the blender jug/mill container or
remove accumulated food residue from the spinner/container cover and ensure that the amount used is as stated.
(For blender jug, it also can add liquid.)
●
Ensure that the ingredients are cut into the stated sizes.
●
Remove the prohibited ingredient if used.
3
Reset the attachment, then start again. (P. EN7)
If the appliance still does not operate after performing the above, overheating protection has been activated.
Turn the rotary switch to "0" position, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a
normal temperature) to release overheating protection before using again.
(If appliance still does not operate, Contact Panasonic Service Centre for inspection or repair.)

Parts Names and Instructions

■
Blender
Cover
Blender Jug
Maximum amount
approx.1.0 L
One scale
Container
approx. 0.2 L
Spout
Blender Gasket
Juice Cup
Blender Blade
(Approx. 1.5 L)
Blender Jug Base *1
Clamps
(Both sides)
Power Plug *2
Power Cord
1000
800
600
400
*1 The blender jug base and the mill container
*2 The shape of the plug may be different from
■
Rotary Switch
Motor Housing
■
Wet & Dry Mill
Mill Container Base *1
base cannot be used interchangeably.
illustration.
Accessory
Brush
2
High speed (continuous operation)
1
Low speed (continuous operation)
0
OFF
Mill Container
Mill Gasket
Mill Blade
EN5