Panasonic MJ-CB800 Operating Instructions Manual page 4

Do not use the appliance if the power cord or power plug is damaged or the power plug is
●
loosely connected to the outlet.
If the power cord is damaged, it must be replaced by the manufacturer, its service centre or
➜
similarly qualified person in order to avoid a hazard.
Insert the power plug firmly.
➜
Do not immerse the motor housing, power cord or power plug in water, or splash it with
●
water and / or any liquid.
Do not remove pulp container, blender jug, mill container when the appliance is operating.
●
This appliance is not intended for use by persons (including children) with reduced
●
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Keep the appliance and its power cord out of reach of children.
●
Dust off the power plug regularly.
●
Unplug the power plug, and wipe with a dry cloth.
➜
Discontinue using the appliance immediately and unplug in the unlikely event that this
●
appliance stops working properly.
e.g. for abnormal occurrences or breaking down
The power plug or the power cord become abnormally hot.
●
The appliance power fails.
●
The motor housing is deformed, has visible damage or is abnormally hot.
●
There is damage or crack on the blender jug, the spinner (rotating sieve), the container cover
●
(protection cover) or other parts.
There is an unpleasant smell.
●
There is abnormal turning noise while in use.
●
There is another abnormality or failure.
●
Contact Panasonic Service Centre for inspection or repair.
➜
Make sure the voltage indicated on the label of the appliance is the same as your local supply.
●
Also avoid plugging other devices into the same outlet to prevent electric overheating. However,
if you are connecting a number of power plugs, make sure the total wattage does not exceed the
rated wattage of the outlet.
Be careful if hot liquid is poured into the blender jug as it can be ejected out of the
●
appliance due to a sudden steaming.
To prevent electric leakage, electric shock, fire caused by short circuit, scald, injury or property damage.
Do not use the appliance on the following places.
●
On uneven surfaces, on carpets or tablecloths etc.
●
Place where it may be splashed with water or near a heat source.
●
Near any open water such as bathtubs, sinks, or other containers.
●
Near a wall or furniture.
●
Place the appliance on a firm, dry, clean flat worktop.
➜
Do not blend or place over 60 °C ingredients into the blender jug or mill container.
●
Never use hot water (over 60 °C) for cleaning purpose or fire to dry the appliance.
●
WARNING
CAUTION
EN3