Hunter Port Royale Installation Manual page 9

Follow these steps to prepare the light fixture for installation.
Remove the pre-installed light kit screw and red
flag from the light kit assembly. Save the screw.
It will be needed for light kit installation.
Note: The screw was installed for shipping purposes only.
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the upper
switch housing to the mounting plate.
Ceiling Bracket Downrod
Preparing the Light Fixture
x1
Light Kit Screw
Red Flag
Installing the Light Fixture Hood
Partially install two switch housing
assembly screws ,found in the
hardware bag, into the motor
housing as shown. It does not matter
which two screw holes you choose.
Hanging Fan Wiring
KEEP
2 of 3
Switch Housing
bag
Assembly Screw
Insert the third screw, found in the
bag, into place and then tighten all three screws.
Canopy Blades
Carefully remove the light kit assembly
from the light kit hood.
Feed the wire plug through the center hole
of the light kit hood. Align the keyhole slots
in the hood with the two screws you just
installed. Lift the hood so that the keyhole
slots engage the two screws, and twist
counterclockwise to lock the hood into place.
1 of 3
Switch Housing
bag
Assembly Screw
hardware
IMPORTANT
Make sure the light kit hood is securely attached
to the mounting plate. Failure to properly secure
all 3 assembly screws could result in the light
kit falling.
Light Bulbs/Cage
1886
8
Remote Cradle