Samsung MULTIXPRESS CLX-9251 Series Service Manual page 321

A3 color copier

Hide thumbs Also See for MULTIXPRESS CLX-9251 Series:

Table of Contents

► Error Code

► Error message

Staple cartridge is low. Replace it.

Staple cartridge is empty. Replace it.

Finisher stapler cartridge is necessary to refill.

► Troubleshooting method

1) Open finisher stapler door to refill cartridge and then close door. Self-Priming will execute automatically if

necessary. If stapler error or warning does not disappear, follow the instructions below :

a) Does finisher stapler cartridge refill box fit well?

i) Make sure stapler refill box fit well into cartridge.

ii) Make sure staples do not jam near stapler head.

b) Does finisher stapler input sensor work well?

i) Make sure finisher input sensor cable is connected well to the sensor connector.

ii) Make sure finisher input sensor cable is connected well to the main board connector.

iii) Replace the finisher stapler(JC81–07376A).

iv) Replace the finisher main board(JC81–09692A).

(Refer to 3.3.34.2. Finisher Board)

c) Check if any debris (staple) is present. Please make sure to remove any debris.

4. Troubleshooting

Troubleshooting