Table of Contents
Advertisement
12
www.aeg.com
such cases, the regeneration prolongs
the total duration of a programme by
additional 5 minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin
in the same cycle or at the beginning of
the next programme. This activity
increases the total water consumption of
a programme by additional 4 litres and
the total energy consumption of a
programme by additional 2 Wh. The
rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible
more than one in the same cycle) may
prolong the programme duration by
another 5 minutes when it occurs at any
point at the beginning or in the middle of
a programme.
All the consumption values
mentioned in this section are
determined in line with the
currently applicable standard
in laboratory conditions with
water hardness 2.5mmol/L
(water softener: level 3)
according to the regulation:
2019/2022 regulation.
The pressure and the
temperature of water as well
as the variations of the
mains supply can change
the values.
How to set the water softener
level
Make sure the appliance is un user
mode.
1. Press
• The indicators
are off.
• The indicator
• The display shows the current
setting: e.g.
2. Press
setting.
3. Press the on/off button to confirm the
setting.
.
,
,
still flashes.
= level 5.
repeatedly to change the
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains. It is
automatically released during the hot
rinse phase.
When the rinse aid chamber is empty,
the rinse aid indicator is turned on
notifying to refill rinse aid. If the drying
results are satisfactory while using multi-
tablets only, it is possible to deactivate
the notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
Make sure the appliance is in user mode.
1. Press
• The indicators
are off.
• The indicator
• The display shows the current
setting.
–
–
2. Press
3. Press on/off to confirm the setting.
6.4 The rinse aid level
It is possible to set the released quantity
and
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press
.
,
,
still flashes.
= the rinse aid empty
notification is deactivated.
= the rinse aid empty
notification is activated.
to change the setting.
.
and
Advertisement
Table of Contents
