Asus M2N-X Manual page 36

3. Serial ATA connectors
(7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA
3.0 Gb/s hard disk and optical disk drives. The Serial ATA 3 Gb/s is
backward compatible with Serial ATA 1.5Gb/s specification.
The current Serial ATA I interface allows up to 150 MB/s data transfer
rate while Serial ATA II allows up to 300 MB/s data transfer rate,
faster than the standard parallel ATA with 133 MB/s (Ultra DMA133).
If you install Serial ATA hard disk drives, you can create a RAID
0, RAID 1, RAID 0+1, RAID 5, and JBOD configuration through the
onboard NVIDIA
M2N-X
M2N-X SATA Connectors
Important note on Serial ATA
Install the Windows
Pack1 before using Serial ATA.
• For detailed instructions on how to configure RAID 0, 1, 0+1, 5,and
JBOD, refer to the RAID manual in the support CD.
• The RAID function of these connectors is set to [Disabled] by
default. If you intend to create a Serial ATA RAID set using these
connectors, enable the RAID Enabled item in the NVRAID
Configuration sub-menu in the BIOS. See section "2.4.3 Onboard
Device Configuration" for details.
1-24
All manuals and user guides at all-guides.com
MediaShield™ controller.
®
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
2000 Service Pack 4 or the Windows
®
SATA2 SATA
GND GND GND
RSATA_TXP2 RSATA_TXP RSATA_TXP
RSATA_TXN2 RSATA_TXN RSATA_TXN
GND GND GND
RSATA_RXP2 RSATA_RXP RSATA_RXP
RSATA_RXN2 RSATA_RXN RSATA_RXN
GND GND GND
®
Chapter 1: Product introduction
SATA
XP Service