Table of Contents
Advertisement
All manuals and user guides at all-guides.com
2.
IDE connectors (40-1 pin PRI_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66/33
signal cable(s). There are three connectors on each Ultra DMA
133/100/66/33 signal cable: blue, black, and gray. Connect the blue
connector to the motherboard's IDE connector, then select one of the
following modes to configure your device(s).
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66/33 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
M2N-X
M2N-X IDE Connector
ASUS M2N-X
Drive jumper
Mode
setting
of device(s)
Cable-Select or Master
-
Cable-Select
Master
Slave
Master
Master
Slave
Slave
PRI_IDE
PIN1
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
Cable
connector
Black
Black
Gray
Black or gray
1-23
Advertisement
Table of Contents
