Table of Contents
Advertisement
Connecting to a PC with VGA and 3.5 mm minijack ...
1.
Make sure the power of HDTV and your PC is turned off.
2.
Obtain a 15-pin D-Sub VGA cable; connect to the VGA output of your PC
and the other end to the VGA port on the back of your HDTV.
3.
Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the
other end to the VGA Stereo Input port.
4.
Turn on the power of the HDTV and your PC.
5.
Use the remote control's source button or the source button on the TV to
switch to VGA.
6.
Change your PC resolution to 1920x1080 at 60hz refresh rate.
7.
Press MENU to use the OSD's SETUP option.
8.
Under the SETUP option select PC function.
9.
Under VGA function use AUTO ADJUST to adjust the screen.
Please Note:
•
For the best results, please set your PC resolution to 1920x1080
at 60 Hz. Please refer to the PC or graphic card's manual for
further instructions on how to set your resolution and refresh rate.
•
Please refer to your PC manual for video output requirements of
the video card.
•
The VGA port of the TV features a power saving mode which will
automatically turn off the TV, if there's no signal provided for
more than 5 minutes.
SCEPTRE X460 HDTV User Manual
- 19 -
www.SCEPTRE.com
Advertisement
Table of Contents
