Clarion NX404AU Owner's Manual page 60

• Use only the supplied parts.
If unspecified parts are used, they may cause damage.
• Any holes made in the body of the vehicle should be sealed with a silicon adhesive. If exhaust fumes or
water penetrates into the vehicle, this may cause an accident.
• Fasten the bolts securely when installing the unit. If the bolts are loose an accident or malfunction could
occur.
Connection Notes
• Loom all cables according to the instruction manual, so as not to hinder operation.
• Wire the connecting cords/cables away from high temperature areas.If the coatings of the cables melt,
it could cause an accident/fire by a short circuit. Take care when wiring in the engine compartment.
• When wiring the connecting cables in a vehicle with an airbag system, never feed the cables through a
place where it may affect the operation of the airbag. An airbag not operating correctly in an emergency
may cause increased injury.
• Verify wires with a digital multi-meter prior to making any connections.Many new vehicles use
multiplexed and/or low voltage circuits that can be damaged if a test light or logic probe is used.
• Connect cables appropriately. If a wrong connection is made, this may cause a fire or accident.
• When passing cables through the body of the vehicle, use non-conductive grommets. If the coatings of
the cables are worn out by rubbing, this may cause an accident, fire or a short circuit.
• After wiring cables, fix them with insulation tape.
• Be sure to switch off the vehicle when connecting or disconnecting cords to/from the unit, otherwise an
electric shock, injury or accident may occur.
CAUTION
WARNING
CAUTION
NX404AU 59