Advertisement
STEP #4: INSTALL ROM AJUST
1. Locate one of the Leverage ROM ADJUST to install. On the end with the spherical rod, insert two misalignment
bushings and two O-rings, one bushing and one O-ring on each side of the rod end as shown below.
2. Slide the assembled rod end into the stainless steel strap bracket then install one (M10 X 40MM, SHOULDER BOLT),
two (M10 FLAT WASHERS), and a (M8, NYLOCK NUT). Tighten to specified torque using a 5MM hex key,13MM socket-
torque wrench.
3. Slide the lower end of the ROM ADJUST onto the Leverage weight arm mount as shown below. Install one (M10 X
25MM, SOCKET HEAD BOLT) and one (M10 FLAT WASHER) and torque to the specified torque.
4. Repeat steps 1 thru 3 with the remaining Leverage ROM ADJUST.
NOTE: When completed test the motion of the Leverage machine to ensure smooth quiet operation.
STEP#4: Completed
Page 14
Advertisement
