Keyboard; Removing The Keyboard - Dell P174G Service Manual

Steps
1. Place the power button into its slot on the palm-rest and keyboard assembly.
2. Adhere the fingerprint reader flexible printed circuits to the connector on the palm-rest and keyboard assembly.
NOTE: This step applies only to computers shipped with a power button with fingerprint reader installed.
3. Align the screw hole on the power button with optional fingerprint reader to the screw hole on the palm-rest and keyboard
assembly.
4. Replace the two screws (M1.6x1.7) to secure the power button to palm-rest and keyboard assembly.
Next steps
1. Install the I/O daughter-board.
2. Install the system board.
3. Install the heatsink.
4. Install the WWAN card.
NOTE: This procedure applies only to computers shipped with a WWAN card installed.
5. Install the base cover.
6. Follow the procedure in

Keyboard

Removing the keyboard

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the solid-state
4. Remove the WWAN card.
NOTE: This procedure applies only to computers shipped with a WWAN card installed.
5. Remove the 2-cell battery
62 Removing and installing components
After working inside your
Before working inside your
drive.
or the3-cell battery, whichever is applicable.
computer.
computer.