Wlan-Antenna Module; Removing The Wlan-Antenna Module - Dell P174G Service Manual

Hide thumbs Also See for P174G:

Setup and specifications (32 pages)

Setup and specifications (36 pages)

Owner's manual (146 pages)

Table Of Contents

Table of Contents

Steps

1. Place the system board into the respective slot on the palm-rest and keyboard assembly.

NOTE:

Transfer the reusable WLAN absorbers to the new system board while replacing the system board.

2. Replace the two screws (M2.2x5) and three screws (M2x4)securing the system board in place.

3. Connect the (1) camera cable, (2) display cable, (3) clickpad flexible flat cable, and (4) USH daughter board flexible flat

cable (for models shipped with a USH daughter board) on the system board.

4. Replace the I/O daughter-board bridge connector board on the system.

NOTE:

When re-installing the I/O daughter-board bridge connector board align the connector so that the arrows

etched on the connector are pointed upward towards the heat-sink and fan assembly.

NOTE:

When re-installing the I/O daughter-board bridge connector board secure the six screws (M2x4) in sequential

order (1 > 2 > 3 > 4 > 5 > 6) marked on the FPC.

5. Replace the six screws (M2x4) securing the I/O daughter-board bridge connector board in place.

6. Align and place the display cable bracket on the system.

7. Replace the two screws (M2x2) securing the display cable bracket on the system board.

8. Connect the WLAN Main and Aux antenna to the WLAN module.

9. Replace the WLAN module bracket on the system.

10. Replace the single screw (M2x2) screw securing the WLAN module bracket in place.

Next steps

1. Install the heat-sink.

2. Install the

2-cell battery

3. Install the

M.2 2230 solid-state

4. Install the

base

cover.

5. Follow the procedure in