Table of Contents
Advertisement
Figure 10. Remove the speakers
Remove the coin-cell battery
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 33
"Remove the battery pack" on page 34
Step 1.
Disconnect the cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 11. Disconnect the cable
Step 2.
Remove the coin-cell battery as shown.
.
Chapter 4
Removing a FRU or CRU
37
Advertisement
Table of Contents
