Table of Contents
Advertisement
Figure 28. Disconnecting a BPM cable from the NVDIMM
e) Place the NVDIMM on an appropriate ESD surface.
f) Repeat steps "12.a" on page 29 through "12.e" on page 31 for any additional NVDIMMs.
13. Remove the backup power modules and backup power module cables, if present. Otherwise,
continue with the next step.
Note: The BPM (BPM) is mounted in a standard drive carrier. The BPM is handled as a drive in this
procedure.
a) If your system has more than one BPM, record the location of both BPMs and decide which BPM
you want to remove first.
b) Provide slack in the BPM cable by pulling the BPM cable forward about 5 cm (2 in) in the direction
shown in Figure 29 on page 32.
Removing and replacing the system backplane in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H,
or 9223-22S 31
Advertisement
Table of Contents
