Table of Contents
Advertisement
Figure 26. Removing the NVMe U.2 pass-thru card
c) Place the NVMe U.2 pass-thru card on an appropriate ESD surface.
d) If a second NVMe U.2 pass-thru card is present, repeat steps "11.a" on page 27 through "11.c" on
page 29.
12. Remove the non-volatile dual in-line memory modules (NVDIMMs), if present. Otherwise, continue
with the next step.
a) Record the slot location of the NVDIMM you want to remove. Then, review and record the
locations where the backup power module (BPM) cable connects to the NVDIMM and to the BPM.
b) To unlock the NVDIMM from its connector, simultaneously push both of the locking tabs away
from the module in the direction that is shown in Figure 27 on page 30.
The lever action of the tabs pushes the NVDIMM out of the connector. If you find it hard to open
the tabs with your fingers, you may use the tips of ball point pens, or the eraser ends of pencils.
The levers must be opened simultaneously, so that the NVDIMM lifts straight up.
Removing and replacing the system backplane in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H,
or 9223-22S 29
Advertisement
Table of Contents
