18 SERVICE WORK ON THE ENGINE
18.2
18.3
136
Checking the engine oil level
K00578-10
Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Drain engine oil with engine at operating temperature.
K00567-10
–
Start the engine and check the response.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Condition
The engine is at operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute
before checking the level.
The engine oil is at a level between the lower edge
and the middle of the level viewer
»
If the engine oil is not up to the lower edge
level viewer:
–
Add engine oil. (
Preparatory work
(EXC‑F AU, EXC‑F Six Days)
–
Remove the engine guard. (
–
Park the motorcycle on a level surface.
Main work
–
Place a suitable container under the engine.
–
1
Remove oil drain plug
Info
Do not remove screws
B
.
A
p. 138)
p. 94)
with the magnet and seal ring.
2
.
A
of the