Sanyo VPC-SX560E Instruction Manual page 25

4
When finished (the recharge indicator turns off), unplug the power cord from the
power outlet.
5
Remove the batteries from the battery charger.
Recharge
indicator
Recharge indicator
The recharge indicator allows you to check the condition of the battery charger. If the recharge
indicator begins flashing, it indicates a problem. Refer to the table below to check the battery
charger condition.
Recharge indicator
Off
On
Slow flashing
(one flash/2-second:
Model NC-LC03WSA
only)
(one flash/second:
Model VAR-NC1 only)
Fast flashing (four
flashes/second:
Model VAR-NC1 only)
Model NC-LC03WSA
Condition of battery charger
Power is not supplied to the battery charger.
œ Plug the power cord into a power outlet when using the battery
charger. Charging is complete.
œ Unplug the power cord from the power outlet.
Charging.
There is a problem with the batteries.
Immediately remove the batteries and make sure that the batteries are
*
not overheating.
œ Once the faulty batteries are removed and only good batteries
remain, the recharge indicator will stop flashing and remain lit.
You can now resume charging.
œ Do not use faulty batteries.
There is a problem with the battery charger (perform the procedures
given below).
(1) Immediately unplug the power cord from the power outlet.
(2) Check for smoke or other problems.
(3) If a problem exists, stop using the battery charger and contact the
place of purchase.
(4) If there is no problem, plug in the battery cord and check the
recharge indicator.
œ If it lights, the battery charger is ready for use.
œ If it begins flashing again, unplug the power cord and contact the
place of purchase.
Recharge
indicator
Model VAR-NC1
22
English