Stamina 35-1397A Owner's Manual page 13

OPERATIONAL INSTRUCTIONS
HOW TO INSTALL AND REPLACE BATTERIES:
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AAA batteries (1.5V each), the
batteries are not included. Refer to the illustration to install or
replace the batteries.
NOTE: 1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according to
all state and federal laws and regulations.
5. Do not dispose of batteries in fire.
LOAD ADJUSTMENT
To increase the load, turn the TENSION KNOB(56) clockwise. To
decrease the load, turn the TENSION KNOB(56) counterclockwise.
There are eight levels for the load adjustment.
NOTE: The load will increase as you pull faster.
PEDAL STRAP ADJUSTMENT
If you feel it is more comfortable for your workout, you can attach the PEDAL STRAP(44) to the lower
position in the PEDAL CAP(43) as shown in illustration 1 below. Run the PEDAL STRAP(44) through the
opening from the bottom of the PEDAL CAP(43). Pull the PEDAL STRAP(44) to place the Knot against the
bottom of the PEDAL CAP(43). Run the PEDAL STRAP(44) through the opening in the PEDAL CAP(43)
on the other side from the top as shown in illustration 1, then pull the end of the PEDAL STRAP(44) up to
attach onto the upper part of the PEDAL STRAP(44) with the Hook & Loop Pad.
Attach the end of the PEDAL STRAP(44) to different position with the Hook & Loop Pad to adjust the length.
Refer to illustration 2.
1.
Hook & Loop Pad
Knot
End of Pedal Strap
13
AAA Batteries
56
Hook & Loop Pad
2.