Sanyo PLV-Z3000 Owner's Manual page 52

Sanyo plv-z3000: user guide
Hide thumbs Also See for PLV-Z3000:
Table of Contents

Advertisement

Appendix
Problem:
Horizontal line noise occurs.
Image is Left/Right reversed.
Image is Top/Bottom reversed.
The edge of the image is distorted.
Auto adj. does not work.
Image is distorted or runs off.
Some displays are not seen
during operations.
The setting does not remain after
turning off power.
Power management does not work.
Image disappears automatically.
Capture function does not work.
Some menus cannot be selected.
Switching between HDMI 1 and
HDMI 2 takes time.
Image does not appear with HDMI 1
or HDMI 2.
The Remote Control does not work.
RESET button does not work.
LOGO button does not work.
Indicators blinks or lights.
Abnormal noise is detected during
projection.
The exclamation mark appears on
the screen.
WARNING:
High voltages are used to operate this projector . Do not attempt to open the cabinet .
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or
service center. Give the model number and explain about the problem. We will advise you how to obtain service.
52
– Solutions
– When connecting HDTV equipment to the projector's COMPONENT 1/2 terminals,
horizontal line noise may be noted only occasionally. Then adjust the value of Fine
sync. (see page 34).
– Check the Ceiling/Rear item (see page 37).
– Check the Ceiling item (see page 37).
– With maximum lens shift, image distortion may be observed (see page 14).
– The Auto adj. function cannot be operated with the video input, some incompatible
computer input and digital signals (see page 34).
– Check "Picture adj. " menu or "Screen" menu and adjust them.
– Check the Display item (see page 40).
– Make sure you selected "Store" after adjusting settings. Some settings cannot be
stored if not registered with "Store. "
– When "Freeze (p. 23), " "No show (p.23), " "Cleaning (p.42), " or "Test pattern (p.42)"
are operating or Logo is displayed, the power management function cannot be
operated (see page 41).
– Check the power management function in the Setting. The power management is
set to "On" at the factory (see page 41).
– Check the connection to see if there is signal.
– Check the connection to see if there is signal. "Image, " "Image adj., " "Picture adj., "
and "Screen" cannot be selected without an input signal.
– When switching from HDMI 1 to HDMI 2 or vice versa, the signal may be
interrupted for a moment depending on the equipment (see page 26).
– Turn on the Video equipment again.
– Check the connection of cables.
– Check the batteries.
– Make sure there is no obstruction between the projector and remote control.
– Make sure you are not too far from the projector when using the remote control.
Maximum operating range is 16.4' (5 m).
– Make sure the code of the remote control is conformed to that of the projector (see
page 41).
– This function is limited to when selecting the Image Adjustment Menu and Picture
Adjustment Menu (see page 22).
– Check the Logo setting. Make sure Logo is not set to off. (see page 40).
– Check the status of the projector with referring to "Indicators and Projector
Condition" (see page 53).
– Motor noise or shutter noise can be heard when selecting or switching "Image, " or
projecting an image with the large brightness fluctuation.
– Your operation is invalid. Operate correctly.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plv z3000 - lcd projector - hd 1080p

Table of Contents