The following symbols are used on the product: Risk of crushing injury! Wireless data transfer Hilti Li-ion battery type series used. Observe the information given in the section headed In- tended use. English Printed: 26.10.2018 | Doc-Nr: PUB / 5449516 / 000 / 01...
The type designation and serial number are printed on the rating plate. ▶ Write down the serial number in the table below. You will be required to state the product details when contacting Hilti Service or your local Hilti organization to inquire about the product. Product information...
Page 8
▶ Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. ▶...
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height or show signs of damage. In this case, always contact your Hilti Service. ▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable location, well away from flammable materials, where it can be kept under observation and allowed to cool down.
▶ Use only Hilti lithiumion batteries of the B 22 series with this product. ▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
'Troubleshooting' section. Items supplied Crimping / pressing tool, operating instructions. Other system products approved for use with this product can be found at your local HILTI STORE or online at: www.hilti.group Selecting the crimping / pressing die A table to assist with selecting the type of crimping / pressing die to be used can be found at the end of these operating instructions.
Never operate the product without a crimping die installed. 1. Remove the battery and select the most suitable crimping / pressing die. 2. Push the crimping / pressing dies in until they engage. 3. Rotate the crimping / pressing head to the desired working position. The crimping / pressing head can be rotated much more easily when not under pressure.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare parts, consumables and accessories approved by Hilti for use with the product can be found at your local Hilti Store or online at: www.hilti.group.
▶ Check the tool and batteries for damage before use after long periods of storage. Troubleshooting If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by yourself, please contact Hilti Service. The crimping / pressing tool is not in working order. Malfunction...
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting. ▶ Dispose of your battery out of the reach of children. ▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public health and safety resources for disposal instructions.