Sharp AQUOS BOARD 4W-B65FT5U Operation Manual page 63

[ENGLISH]
Contents
1. Part Names
2. Introduction
3. Direct Button Operation
4. On-Screen Display Menu
5. Application
6. Using a PC
7. Using the touch function
8. Appendix
1. Setting the TV on the Wall
2. Troubleshooting
9. Specifications
10. Trademarks
11. Dimensional Drawings
Ver. 1.1
>> Appendix
<< Setting the TV on the Wall
For 4W-B55FT5U and 4W-B65FT5U
• Screws which suits for each models are set in the box.
• Especially, 55", 65" models are different length screws required for either upper side and lower side.
• Screws for each upper and lower side are packed to separate bags (55", 65" models).
• Please take care length of screws.
- Long length screws: for upper side
- Short length screws: for lower side
For Rest of models
• Screw length is the same for upper side and lower side.
• 4 pcs. of sleeves are set in the box. Please insert these to each VESA holes before fasten screws.
For the screws, refer to the table shown below.
4W-B55FT5U and 4W-B65FT5U
Standard screws
Upper side
Length(Depth of
mounting holes)
Lower side
Quantity
NOTE
• To use this TV mounted on a wall, remove the cable tie as needed.
• Do not use screws that do not comply with the VESA standard screw specifications.
• Do not use screws that are longer than the standard length. Screws that are too long may cause damage to the inside of the TV.
• Do not fasten the screws too firmly or loosely. This may damage the product or cause the product to fall, leading to personal injury. SHARP is not
liable for these kinds of accidents.
• SHARP is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is used, or the consumer fails to follow the
product installation instructions.
Do not install the wall mount kit while your TV is turned on. It may result in personal injury due to electric shock.
4W-B75FT5U
M6 (1.0 pitch) M8 (1.25 pitch)
33 mm
24 mm
10 mm
4 pcs. (set in the box)
Unit mm
4W-B86FT5U
M8 (1.25 pitch)
30 mm
4 pcs.
en-US 62