Configuring The Ibrix Cluster For Insight Remote Support - HP IBRIX 9300 Administrator's Manual

Limitations
Note the following:
For IBRIX systems, the HP Insight Remote Support implementation is limited to hardware events.

Configuring the IBRIX cluster for Insight Remote Support

To enable 9300/9320 systems for remote support, first register MSA disk arrays and then configure
Phone Home settings. All nodes in the cluster should be up when you perform this step.
NOTE: Configuring Phone Home removes any previous IBRIX snmp configuration details and
populates the SNMP configuration with Phone Home configuration details. When Phone Home is
enabled, you cannot use ibrix_snmpagent to edit or change the snmp agent configuration.
However, you can use ibrix_snmptrap to add trapsink IPs and you can use ibrix_event to
associate events to the trapsink IPs.
Registering MSA disk arrays
To register an MSA disk array with the cluster, run the following command:
# ibrix_vs -r -n STORAGENAME -t msa -I IP(s) -U USERNAME [-P PASSWORD]
Configuring Phone Home settings
To configure Phone Home on the GUI, select Cluster Configuration in the upper Navigator and
then select Phone Home in the lower Navigator. The Phone Home Setup panel shows the current
configuration.
Click Enable to configure the settings on the Phone Home Settings dialog box. Skip the Software
Entitlement ID field; it is not currently used.
22 Getting started