Environmental Protection; Technical Specifications - Metabo KS 18 LTX 66 BL Original Instructions Manual

Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
See page 4.
A Dust bag
B Guide rail
C Mitre rail
D Fast-action clamp clip. To secure the guide rail.
E Circular saw blades. For clean cutting results
for straight and cross cuts in soft and hard
wood.
F Battery charger
G Battery packs with different capacities. Only
buy battery packs only with voltage suitable for
your power tool
H Metabo universal vacuum cleaner
I Suction hose
For a complete range of accessories, see
www.metabo.com or the catalogue.
11. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

12. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).

13. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
U = Voltage of battery pack
n = idle speed
0
T = maximum depth of cut
max
T = adjustable depth of cut (90°)
90°
T = adjustable depth of cut (45°)
45°
A = adjustable angular cut angle
Ø = saw blade diameter
d = saw blade drill diameter
a = max. base body thickness of the saw
blade
b = max. cutting width of saw blade
m = weight
Measured values determined in conformity with
EN 62841.
Permitted ambient temperature during operation:
-20 °C to 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
direct current
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = Vibration emission value
h, D
(Sawing chip board)
K = Uncertainty (vibration)
h,D
Typical A-effective perceived sound levels:
L = sound-pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
ENGLISH en
17