Graco S20 Operation page 35

Disconnected Solenoid Diagnostic Code
Screen
See F . 36. If the system detects a disconnected air
IG
motor solenoid and the E4 Diagnostic Code is enabled,
the Disconnected Solenoid screen becomes active.
F . 36: Disconnected Solenoid Diagnostic Code
IG
Screen
1. Press and release
Solenoid screen.
2. Correct the condition causing the diagnostic code;
see Table 4: Diagnostic Codes on page 37.
3. This diagnostic code will automatically clear when
the system detects that the solenoid is connected.
313526S
to exit the Disconnected
Drum Low/Empty Diagnostic Code Screen
See F . 37 and F . 38. If the drum low/empty sensor
IG IG
trips, the Drum Low or Drum Empty screen becomes
active, depending on which sensor setting is chosen.
See page 32.
F . 37: Drum Empty Diagnostic Code Screen
IG
F . 38: Drum Low Diagnostic Code Screen
IG
1. Press and release
screen. This will set the diagnostic code as a
standing diagnostic code. A standing diagnostic
code has not been cleared, simply acknowledged.
2. Replace the low or empty drum with a full drum.
When the sensor no longer detects a low or empty
drum the diagnostic code will clear automatically.
Remote DataTrak Operation
to exit the Drum Low/Empty
35