Graco S20 Operation page 34

Remote DataTrak Operation
Diving Up Diagnostic Code Screen
See F . 34. If the pump shows diving up symptoms
IG
and the E1 Diagnostic Code is enabled, the Diving Up
screen becomes active.
F . 34: Diving Up Diagnostic Code Screen
IG
1. Press and release
This will set the diagnostic code as a standing
diagnostic code. A standing diagnostic code has
not been cleared, simply acknowledged.
2. Correct the condition causing the diagnostic code.
See Table 4: Diagnostic Codes on page 37.
3. To clear the diagnostic code, navigate to the Diving
Up diagnostic screen.
a. Press and release
Mode from Run Mode.
b. Press and release
Diagnostic screen, or return to the previous
Run screen if no other Diagnostic screens are
active.
c. Press and hold
Diving Up Diagnostic screen to clear the
diagnostic code and scroll to the next available
Diagnostic screen, or return to the previous
Run screen if no other Diagnostic screens are
active.
34
to exit the Diving Up screen.
to enter Diagnostic
to scroll to the Diving Up
for 3 seconds while on the
Diving Down Diagnostic Code Screen
See F . 35. If the pump shows diving down symptoms
IG
and the E2 Diagnostic Code is enabled, the Diving
Down screen becomes active.
F . 35: Diving Down Diagnostic Code Screen
IG
1. Press and release
screen.
2. Correct the condition causing the diagnostic code.
See Table 4: Diagnostic Codes on page 37.
3. To clear the diagnostic code, navigate to the Diving
Down diagnostic screen.
a. Press and release
Mode from Run Mode.
b. Press and release
Down Diagnostic screen, or return to the
previous Run screen if no other Diagnostic
screens are active.
c. Press and hold
Diving Down Diagnostic Screen to clear the
diagnostic code and scroll to the next available
Diagnostic screen, or return to the previous
Run screen if no other Diagnostic screens are
active.
to exit the Diving Down
to enter Diagnostic
to scroll to the Diving
for 3 seconds while on the
313526S