Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro TimeCutter MX 5000 Operator's Manual

Adjusting the Height of Cut

Note:
The transport position is the highest
height-of-cut position or cutting height at 114 mm
(4-1/2 inches) as shown in
You can adjust the height of cut from 38 to 114 mm
(1-1/2 to 4-1/2 inches) in 13 mm (1/2 inch) increments.
The height of cut is controlled by the lever located to
the right of the operating position
Figure 24
Figure 24.
(Figure 24).
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers
the closest height-of-cut position.
1. Anti-scalp roller
2. Bolt
g296586
26
ARK
(Figure 25) to match
Figure 25
3. Flange nut
4. Hole spacing
g010233