Using Direction Indicators - Volvo V60 CROSS COUNTRY 2020 Owner's Manual

LIGHTING
||
If this symbol is shown in the driver
display, together with the message
Active High Beam Temporarily
unavailable , then switching
between main and dipped beam must be per-
formed manually. The
guishes when these message are shown.
The same applies if this symbol is
shown together with the message
Windscreen sensor Sensor
blocked, see Owner's manual
Active main beam may be temporarily unavail-
able e.g. in situations with dense fog or heavy
rain. When active main beam becomes availa-
ble again, or the windscreen sensors are no
longer blocked, the message goes out and the
symbol illuminates.
WARNING
Active main beam is an aid for using the
optimum beam pattern when conditions
are favourable.
The driver always bears responsibility for
manually switching between main and
dipped beam when traffic situations or
weather conditions so require.
Related information
Lighting control (p. 150)
•
Using main beam (p. 154)
•
156
Limitations for camera and radar unit
•
(p. 422)
symbol extin-
.

Using direction indicators

The car's direction indicators are operated
with the left-hand stalk switch. The direction
indicator lamps flash three times or continu-
ously, depending on how far up or down the
stalk switch is moved.
Direction indicators.
Short flash sequence
Move the stalk switch up or down to the
first position and release. The direction
indicator lamps flash three times. If the
function is deactivated via the centre dis-
play, the lamps will flash once.