Graco Ultra Max 695 Manual page 12

Motor Brush Replacement
795/1095 Motor Brush Installation
CAUTION
When installing brushes, follow all steps carefully to
avoid damaging parts.
7. Fig. 9. Install new brush (G) with lead in long slot
(J) of brush holder (C).
8. Fig. 8. Slide brush lead (E) under washer of termi-
nal screw (D) and tighten screw. Be sure motor
lead (F) is connected at terminal screw.
9. Fig. 9.Place spring (H) on brush (G).
10. Fig. 9. Install spring clip (A). Push down to hook
short slots (K) in brush holder (C).
NOTE SPRING COIL DIRECTION
Fig. 9
12
309251
C
K
J
G
A
E
H
01227
11. Repeat for other side.
12. Test brushes.
a. Remove pump connecting rod pin.
b. With sprayer OFF, turn pressure control knob
fully counterclockwise to minimum pressure.
Plug in sprayer.
c. Turn sprayer ON. Slowly increase pressure
until motor is at full speed.
CAUTION
Do not run sprayer dry for more than 30 seconds
while checking brushes to avoid damaging displace-
ment pump packings.
13. Install brush inspection covers and gaskets.
14. Break in brushes.
a. Operate sprayer 1 hour with no load.
b. Install connecting rod pin.
15. Fig. 4. Install gaskets and inspection covers (B)
on each side of motor. Install motor shield (90).