Craftsman PRO Series Operator's Manual page 9

ASSEMBLY
Set-Up
Chute Clean-Out Tool
Never use your hands to clear a clogged chute assembly. Shut off engine and
remain behind handles until all moving parts have stopped before using the
clean-out tool to clear the chute assembly.
A chute clean-out tool is fastened to the top of the auger housing with a mounting
clip. See Figure 7. The tool is designed to clear a chute assembly of ice and snow. This
item is fastened with a cable tie at the factory for shipping purposes. You may cut
the cable tie and remove at this time.
WARNING
Clean-out Tool
Figure 7
ASSEMBLY
Drift Cutters
The snow thrower drift cutters are mounted inverted at the factory for shipping
purposes.
1. Remove the four wing knobs (two on each side) and carriage bolts. Place
drift cutter in upright position and re-secure. See Figure 8.
IMPORTANT: Make sure to install the wing nuts on the outside of the auger
housing when re-assembling the drift cutters. The wing nuts are only
positioned on the inside of the housing for shipping purposes.
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins have been included
with your snow thrower. There are holes provided in the plastic dash panel for
convenient storage of the shear pins. Push the pins through the holes in the dash
panel and secure with the bow-tie cotter pins. See Figure 9.
NOTE: If the shear pins are not installed in the panel they can be found in the
manual bag.
9 9
Figure 8
Figure 9