Section 5: Unpacking Instructions; Section 6: Set-Up Instructions - White LC 215 Operator's Manual

SECTION 5: UNPACKING INSTRUCTIONS

REMOVE UNIT FROM CARTON
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
• Remove loose parts if included with unit (i.e., owner's manual, etc.).
• Cut along dotted lines and lay carton down flat.
• Remove packing material.
• Roll or slide unit out of carton. Check carton thoroughly for loose parts.
DISCONNECT SPARK PLUG WIRE
Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground it against the
engine by attaching rubber boot to a bolt or metal clip to the grounding post on the engine. See Figure 3.

SECTION 6: SET-UP INSTRUCTIONS

NOTE: Reference to right or left hand side of the mower is observed from the operating position.
IMPORTANT: This unit is shipped WITHOUT GASOLINE OR OIL in the engine. Be certain to service engine with
fresh gasoline and oil as instructed in the seperate engine manual before operating your mower
SETTING UP YOUR LAWN MOWER
Remove unit from carton and follow steps 1 through 9 to set up your lawn mower.
Step 1. Remove grass bag from unit and set it out of
the way.
Grass
Bag
Spark Plug Wire
Figure 3
Upper
Handle
Spark Plug
Step 2. Pull up the upper handle in the direction
shown below. Align it with lower handle.
Lower
Handle
7
Upper
Handle