Section 10: Maintenance - White LC 215 Operator's Manual

SECTION 10: MAINTENANCE

WARNING:
maintenance.
NOTE:
When tipping the unit, empty the fuel tank and keep the engine with the discharge chute side up. Never
tip the mower more than 90 degrees and do not leave the mower tipped for any length of time. Oil can drain into
the upper part of the engine or air filter element causing a starting problem.
ENGINE
Refer to the separate engine manual for all engine maintenance instructions.
• Maintain engine oil as instructed in the separate engine manual packed with your unit. Read and follow
instructions carefully.
• Service air cleaner every 25 hours under normal conditions. Clean every few hours under extremely dusty
conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced.
To service the air cleaner, refer to the separate engine manual packed with your unit.
• The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is
recommended at the start of each mowing season; check engine manual for correct plug type and gap
specifications.
• Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to
permit proper air circulation which is essential to engine performance and life. Be certain to remove all
grass, dirt and combustible debris from muffler area.
DECK
The underside of the mower deck should be cleaned after each use to prevent a buildup of grass clippings,
leaves, dirt or other matter. If this debris is allowed to accumulate, it will invite rust and corrosion, and may prevent
proper mulching, discharge or bagging.
The deck may be cleaned by tilting the mower and scraping clean with a suitable tool (make certain the spark plug
wire is disconnected).
CUTTING BLADE REMOVAL, REPLACEMENT AND SHARPENING
• When removing the cutting blade for sharpening or replacement, protect hands by wearing heavy gloves or
using a heavy rag to hold the blade.
• Remove the bolt and the blade bell support which hold the blade and the blade adapter to the engine
crankshaft.
• Remove the blade and the blade adapter from the crankshaft.
Be sure to disconnect and ground the spark plug wire before performing any repairs or
Blade
Adapter
Blade Bell
Support
Hex Bolt
Figure 9
16