Section 8: Operation - White LC 215 Operator's Manual

SHIFT LEVER
The shift lever is located on the drive clutch control housing on the upper handle. See Figure 4. This lever is used
to select the forward speed of the mower. When changing speed selection, release the drive clutch control.
NOTE:
Move the shift lever only when the engine is running. Changing the shift lever setting with the engine off
can cause damage to the mower's drive system.
CASTER LOCK
Warning:
When operating mower on hills, front wheels should be locked in the straight ahead position.
The casters can be locked in a straight ahead position or can be left to swivel freely.
• Lift and place the lock pins in the larger holes to lock the wheels for straight-ahead operation.
• Place pins in smaller holes to allow casters to rotate freely for turning.
ENGINE CONTROLS
See the engine manual for the location and function of the controls located on the engine.

SECTION 8: OPERATION

WARNING:
operation of any lawn mower can result in foreign objects being thrown into the eyes, which can result in
severe eye damage. Always wear safety glasses or eye shields.
NOTE:
For best results, raise the cutting position until it is determined which height is best for your lawn. See
"Cutting Height Adjustment" in the ADJUSTMENTS section.
GAS AND OIL FILL-UP
Service the engine with gasoline and oil as instructed in the separate engine manual. Read all instructions
carefully.
WARNING:
cool for at least two minutes after running.
EACH TIME BEFORE YOU START YOUR MOWER
ELECTRIC START UNITS ONLY:
Warning:
The battery contains corrosive fluid and toxic material — HANDLE WITH CARE. Keep away
from children. Do not puncture disassemble, mutilate or incinerate. Explosive gasses could be vented
during charging or discharging. Use in a well-ventilated area away from sources of ignition.
Charging Instructions: Charge battery for approximately 16 hours before initial use. However, do not charge
longer than 20 hours.
MPORTANT: Use only the battery charger supplied with this mower.
Keep hands and feet away from the chute area on the cutting deck. See Figure 1. The
Never fill fuel tank indoors, with engine running or until the engine has been allowed to
10