Appliance Location; Leveling Screw, Leg Or Castor Installation - True GDM-26-HC~TSL01 Installation Manual

Installation & Setup (cont.)

Appliance Location

• Ensure that the drain hose or hoses are positioned in the pan.
• Free the plug and cord from inside the lower rear of the
cooler (DO NOT plug in).
• Place the appliance close enough to the electrical supply so
that extension cords are never used.
Leveling Screw, Leg, or Castor Installation
Tipping hazard!
or castors can cause a tipping hazard.
ALWAYS
be sure leveling legs or castors (and shims)
are snug against the rail assembly or mounting plate.
ALWAYS
verify center castors or leveling legs fully
contact the floor after leveling the appliance. See fig.
below.
Leveling legs are provided to assist with leveling the appliance.
Adjustable legs provide 6" (152 mm) of clearance under the
appliance. Castors provide appliance mobility.
Required Tools
Required tools include (but may not be limited to) the following:
• Adjustable Wrench
TEC_TM_105 | REV. D | EN
GDM FREEZER / REFRIGERATOR
WARNING!
Incorrect installation of leveling legs
Procedure – Leveling Screws
If leveling screws are not factory installed, then, with access to the
appliance bottom, install the leveling screws into the threaded
holes in the frame rail or appliance bottom. See figs. 1–3.
Fig. 1. Leveling screw.
Fig. 2. Turn the leveling screws clockwise to lower the appliance.
Fig. 3. Turn the leveling screws counterclockwise to raise the appliance.
05/16/2023
truemfg.com
Page 15 of 40