Loading The Film - Samsung PRONTA 1200 User Manual

LOADING THE FILM

1
1. Open the back cover by sliding the release knob as shown above.
2. Insert a roll of film in the chamber. Do not force the film into position.
3. The film should lie flat.
4. Close the back cover. It will close with a "click".
5. The film will automatically advance until the film counter reads "1".
6. If a film is loaded incorrectly, the LCD panel will display an "E" warning signal. (Refer to page 18 for
information on the buzzer operation) Reload the film following the steps shown above.
NOTE
The camera automatically adjusts for ISO 50-3200 DX film.
When you use non-DX film, the camera will set the film speed at ISO 100.
Load the film in subdued lighting.
2 3
4
5
6
11