Table of Contents
Advertisement
DESCRIPTION
Front Panel
1
2
3
1.
This key is used to turn the receiver on and off (Standby).
2.
,
These keys are used to change the channels.
3.
,
These keys are used to increase and decrease the volume level
manually.
4. 7 Segment Display This LED display will show the current channel number.
While the receiver is in Standby mode, the display will
show the current time.
5. CAM Slot
Slot for Common Interface.(DSR 3800 only)
6. Infrared Sensor
This is to receive the IR commands from the Remote
Control Unit.
7. Not Used
4
5
6
7
8
D
I
G
I
T
A
L
Rear Panel
9
8
1. AC MAINS
2. DISH INPUT
3. LOOP
4. 0/12V OUT
5. RS 232 DATA PORT
6. AV OUT
7. S-VIDEO OUT
8. ANT.IN
9. RF OUT
S
A
T
E
L
L
I
T
E
R
E
C
E
DESCRIPTION
7
6
5
4
3
2
This is to plug in the AC mains power cord.
The input AC voltage range is 120V, 60Hz supply.
This port is to connect the coaxial cable from LNB of your dish.
The IF input is provided through this port and the input frequency
range is 950-2150 MHz. Also the voltage switching 13V and
18V is passed through this port.
To enable the connection of an Analog receiver,
The receiver is provided with this 'LOOP' port.
This is used to connect to an external LNB switch.
This is used to connect your receiver to a computer for reading
and loading data information. (only for service)
These RCA connectors are used to connect any external
video and audio.
This is used to connect STB to your TV by using S-VHS cable.
This is used to connect your local RF channels to
your TV through Loop.
This is used to connect to your TV via RF cable.
(Preset to channel 3)
9
I
V
E
R
1
Advertisement
Table of Contents
