Hunter Astwood Installation Manual page 9

Connect the plug to the lower switch housing. Make sure to line up the colored markings on the connectors and that the connectors
latch. Attach the lower switch housing to the upper switch housing using three light kit screws found in the
Remove and discard the plastic connectors from the ends of the short pull chain.
Attach the pull chain pendants to the light and fan pull chains.
bag
Partially install two cage assembly screws, found
in the hardware bag, halfway into the light
kit as shown. It does not matter which screw
holes you choose.
Ceiling Bracket Downrod
Assembling the LIght Kit
Installing the Pull Chains
The fan pull chain controls
the speed: from high to off.
Installing the Cage
2 of 3
Cage
Assembly
Screw
Lift cage assembly into place while passing pull chains
through cage assembly as shown. Align the keyhole slots
in the top of the cage assembly with the partially installed
cage assembly screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
Note:
Cage will need to be rotated in order to pass
over the sockets.
Hanging Fan Wiring
bag
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
hardware bag.
The light pull chain controls
the light fixture: on and off.
Repeat x2
Insert the third cage assembly screw, found
in the
tighten all the three screws.
NOTE: Check to ensure
proper engagement.
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Canopy Blades
3 of 6
Light Kit Screw
1 of 3
Cage
Assembly
bag
Screw
hardware bag, in place and firmly
WARNING
Bulbs Cage
1886
8